IngramSpark Help Center home page Submit a request

A little confused about size/bleed/etc

Comments

2 comments

  • Erik Istrup Publishing

    You just KEEP the margins and trim size (7x10) and add bleeds in the settings. IF your images are to be printed to edge, you must extend them to cover the bleeds as well. Remember that IngramSpark require a 0.125 (3mm) color free zone at the spine side. I always make a vertical guideline on my Master Sheet 3 mm from the inner edge to guide the images. - Thee screen picture (InDesign) is from another 'support' message, but you can see the trim size 140 x 216 mm (no bleed sizes added) and the bleeds on the three outer edges.

    0
    Comment actions Permalink
  • Lee

    Thanks so much for the response Erik. That makes everything so much easier :)

    0
    Comment actions Permalink

Please sign in to leave a comment.

Support